---

Bobst Speria 106 E (2005)

---

年份: 2005
最大尺寸: 106 x 76 cm (41 x 29 inch)

---

描述:

CUBE control system, Centerline system for quick job changeover, Feed table with 4 front lays, adjustable in pairs with front register control, Feed table with Pull guide OS adjustable according to Centerline marks, with side register control, Feed table with double sheet detector. Mechanical, integrated on pull guide OS , Feed table with sheet-hold down device guiding the sheets to front lays , Feed table with upper transport equipment for paper, paperboard and corrugated board, Feed table with transport belts with lateral guidance and automatic tensionning system , Synchronization device timing the sheet arrival against the front lays when the machine is at a standstill, Pull lay operator side, Manual Non-Stop device Height pile reduced by approximately 200 mm in non-stop mode , Cutting plate with micrometric adjustment for 1 mm thin plates, 1 Die-cutting chase, Grippers re-opening device Platin , Equipment centering and locking on platin, Synthetic material supporting plate on platen Thickness 23.5 mm 0,925 , 1 Upper chase : fixed bottom plate T.101.001 Plate, thickness 2 mm, and make-ready protection plate made of syntethic material, thinckness 1 mm. Cutting size limited to 705 x 1060 mm 27 3/4 x 41 3/4 , 1 Upper stripping pull-out frame, 1 Lower stripping pull-out frame with all its tools, 1 Upper stripping equipment required to create a waste stripping tool, including crossbars, clamps, stripper holders and stripping pins of 3, 5 and 10 mm of diameter, Compensating plate. Thickness 4 mm. In ground steel, Adjustable supporting plate centerings., 1 Upper chase Quick-Lock: fixed bottom Plate, thickness 2 mm, and make-ready protection plate made of syntethic material, thinckness 1 mm., Upper pull-out frame quick lock for stripping Decreases extraction tool assembly times. The quick-closing device allows the tool to be changed in the machine , 1 Lower central pull-out frame quick-lock Stripping Station , Lower stripping equipment for waste stripping including crossbars, pins and supports This equipment mounts on central pull-out frame quick-lock , Outside table for the preparation of the stripping unit, Adjustable rear and side joggers with Centerline marks in delivery, Automatic Non-Stop belt: it is automatically introduced at the exit when the stack of sheets is finished., Control cabinet cooling unit, Cutting force 260 TON, Electronic device for sheet travel control, 7.700 speed/h depending on cardboard and type of iob feature , Board quality processable : carta min. 80g/m² ; cartone 250/2000 g/m² ; corrugate 3 - 4 mm. Carton acceptable warp : 4% of the widthwise sheet, Compliant with European Directives for essential safety and health standards relating to design and construction and with American standards UL 508 and NFPA concerning industrial equipment, Platform, Frame loader die cutting frame turn around : allows the change and preparation of the frame and the die cutting corresponding to the next job Includes an increase in the surface of the platform

---

设备所在地: Europe Western

---

---

交货期: Immediately

---

---

---

---

---

Send Email

Save

---

---

---

---